Tip: Controlling input impedance via Snapshot/footswitch

1 From the Input block, press and turn the Guitar In-Z knob. This activates it for snapshot control.

2 Set the value however you want per snapshot.

For example, if you have three fuzzes in a row followed by an amp (?!), leave the Guitar In-Z set to a lower impedance for any snapshots where a fuzz is on, and set it to 1M Ohm for any snapshots where all three fuzzes are bypassed.

If you have a single fuzz and would prefer to just turn it on and off with a Stomp mode footswitch, you can also do this:

1 Press and hold the Guitar In-Z knob. Helix jumps to the Controller Assign page for that parameter.

2 Press Knob 6 (Learn Controller) and then press the fuzz’s Stomp switch.

3 Set the Min Value to 1M Ohm and the Max Value to whatever impedance sounds right for that fuzz. Now turning the fuzz on and off will also change the impedance circuit.

– from Digital Igloo on the gear page forum.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s